ADM Pulse generator,CS-10 pulse generator

ADM CS-10 series Pulse generators:

CS10-3 Pulse generator use for control the stepper motor and servo motor,

and controlled speed range is: 0-4000RPM，

Square wave, stepless adjustable,

connect button to control start/stop and direction, 

function including set speed, timing, round-trip, fixed length.

Wiring:

Size:   112*60*52 mm

Operating Instructions:

3.    Parameters：

ACC,  Acceleration setting(1-99) 1 means fastest， 99 means slowest, default 5；

tAb, Set Microstep according to the stepper drivers, Micro-step(1-64) , set the same mico-step as the driver, 

default value is 10, (if stepper driver 1/16Micro step, please set 16 here.)

run, Power on operation (0-1) 0 stop status when power on，1 start when power on, default : 0；

In_ _S Run stop input setting (0-4) default value 0:

0, terminal 3 start /stop when connected /unconnected，terminal 4 cw/ccw when connected or not

1, press terminal 3 to change status: start /stop，press terminal 4 to change direction.

2, press terminal 3 to start，press terminal 4 stop.

3, press terminal 3 to change status: start /stop，press terminal 4 change direction/stop.

4, terminal 3 start /stop when connected /unconnected, terminal 4 change direction/stop when

 connected/unconnected

Timing speed control，set P-11 at stop status, set time, then       change speed time display.

X1，X2 and GND connect the limit, when speed control or round trip control, change running

direction when meet the limit，   when displacement control, stop when meet the limit.

HSP high speed setting(1-4000)  default: 1000RPM：

P-01 displacement，pulses=P-01*d1A/dlb

Turn the know to set the speed

P-02 delay value:  0000ms

P-03 times，contiunous  ? times